Powder Resin Insulation Hot Dip Coating Machine Magneto Stator Fluidized Bed

Magneto Stator Fluidized Bed Powder Resin Insulation Hot Dip Coating Machine  WIND-HDP
Magneto motor stator fluidized bed equipment powder resin insulation hot dip coating machine
 
 
 
Design and production reference
 

 
 
 
Working process
 
1. Fix the stator (work piece) in the fixture, then put it inside the inductorium
 
2. Power on the machine, then the induction heater automatically begin working,
 
    the heat time could be set, when set time is reach heater automatically stop,
 
    Normally the heater time is 10s
 
3. Fetch out the fixture,then dip both side in the power coating station,
 
    the stator is hot, and the fixture is in normal temperature and won’t burn you
 
4. Dip the fixture in the power coating station both side, the dipping time is
 
    depened on stator stack thickness and powder’s character,
 
    For example,normally one side is 3s, then the other side 2s
 
5. After dipping, disassemble the fixture clean the fixture using a airgun to
 
    remove the remain power when necessary
 
6. Collect and put the stators into oven( the machine didn’t have a oven with it),
 
    the oven temperature need reach to 180～200℃ (depended on powder’s character),
 
    keep that temperature for more than 30 minutes
 
 
1. Machine is composed of heating,powder coating,powder cleaner and powder recycle system with nice
 
    appearance and reasonable configuration,
 
    the machine frame is made of 1.2mm A3 steel plate
 
2. High frequency indution heater have the advantage of fast heating, low energy, safety and reliability
 
3. Air blowing ensure well done in cleaning fixtures
 
4. Cooling on high frequency induction heater is freezing style water cooler tank, it is well cooling
 
 
 
Machine feature
 
1. Machine is composed of heating,powder coating,powder cleaner and
 
    powder recycle system with nice appearance and reasonable configuration,
 
    the machine frame is made of 1.2mm A3 steel plate,
 
2. High frequency indution heater have the advantage of fast heating, low energy, safety and reliability
 
3. Air blowing ensure well done in cleaning fixtures
 
4. Cooling on high frequency induction heater is freezing style water cooler tank, it is well cooling
 
 
 
Machine configuration
 
Machine dimension L2100×W1720×H2100 mm
 
1. 40KW high frequency induction heater 1PC With Φ120mm inductorium 1PC
 
2. Cooling tank 1PC With size L1000×W1000×H1000mm
 
3. 0.37KW Cooling water pump
 
4. Powder coating chamber 1SET
 
5. Powder recycle system (on back side of powder coating chamber) 1PC
 
 
 
Power composition
 
Power : 12KW 380V±10%,50HZ
 
Compressed air : 0.3 m³/min 0.6Mpa
 
 
 
Please click below picture to view video
 
The weight of armature is related to the lifting fixture for dipping the workpiece (stator  rotor orarmature )
 
to fluidized powder and lifting up(which controlled by cylinder)
 
The pre-heat, coating priciple will be similar as the video showed
 
https://youtu.be/MxBkOsVhDz4
 
The curing oven will be similar as this video last part,
 
https://www.youtube.com/watch?v=88ivvZ-Q1J0