Starter Armature Testing Equipment Spins Rotor During Double Station WIND-ATS-02

Starter Armature Testing Machine Belt Spins The Rotor During The Test WIND-ATS-02

Application:

Starter armature upto 36 slots

covering 13, 17, 19 (few), 21,23,25,27, 28,29,33 slots (common)

Advantages:

1. Moden concept initial positioning, comparing to tranditional starter armature tester,

    the operator no need to check initial positioning manually, 

    Make the testing convenient and easier.

2. 100% Satisfied feedback from starter armature manufacturers. 

Question and Answer:

About you testing machine, could you explain me better about that belt which spins the

armature during the test? Why need to spin, is it better than the common ones? 

You asked a good question about the belt for spin, Yes, it is better than the common ones,

Technical Data:

1. Bar to Bar resistance,0.01mΩ~10mΩ (Out of range display OVER)

    Four-terminal measurement to ensure accuracy

2. Welding resistance,0.001mΩ-10mΩ (Out of range display OVER)

   Six-terminal measurement to ensure accuracy

3. Cross resistance 0.01mΩ-10mΩ

    Four-terminal measurement to ensure accuracy

4. Surge 100-1000V (100V/time)

    Pulse crest:0.5u sec, Frequency 1~40MHz

    Standard waveform is Write, OK waveform is Green, NG waveform is Red

5. Isolation resistance DC 500V

   Testing time:1~10s (0.1s/time)

    Range:1~500MΩ

    Accuracy: ≤±5%

6. Hipot AC 100-1000V

    Testing time:1~10s (0.1s/time)

    Armature commutator bars ≤ 36 bars

   Testing panel cycle time: 8~9s (according to 33bars)

   13, 17, 19 (few), 21,23,25,27, 28,29,33 slots (common)

Main Configuration:

15’’ Touch screen Sampling Chip: BB Relay:NAIS High voltage relay:Meder

Pneumatic parts:Airtec

Power: AC 220V,50Hz

Air pressure:0.4~0.6MPa

Temperature:0~45℃

Dimension: 950mm*1250mm*580mm

HS Code:9030390000